2004 Caldera Spas Aspire Circulation Pump, 72204

SKU:
72204
$0.00
Write a Review
2004 Caldera Spas Aspire Circulation Pump Blue, 1/50 hp, .58A, 115 VAC 60 Hz The circulation pump draws water through the circulation pump filter and then pushes it past the heater, bleedline, ozone (if equipped) injector and back into the spa through the heater return fitting. Its function is to circulate the water through the heater for the maintenance of temperature and to provide continuous filtration of the spa water. The circulation pump uses the water to cool the itself, it may feel hot to the touch. The pump is self lubricating, when operating the impeller rides on a thin layer of water between the ball and the bowl. These pumps should NOT be operated without water present in the spa. The spa should be pre-filled before the spa is connected to power as the pump automatically starts when the spa is operational. A dry run will trip the pumps internal temperature sensor shutting down the pump until the interanal temperature returns to normal. CIRCULATION PUMP REMOVAL INSTRUCTIONS : 1.Disconnect power to the spa. 2.Access the equipment compartment. 3.Unplug the circulation pump from the control box. 4.If the spa is filled with water, clamp the circulation pump inlet and outlet tubing with Hose Clamp Pliers. 5.Remove the bonding wire and base bracket screws. 6.Using Spring Clamp Pliers, slide the spring clamps located on the inlet and outlet fittings back onto the vinyl tubing. 7.Remove the vinyl tubing from the pump inlet and outlet fittings. 8.Disconnect the electrical cord for the old pump. Take note of the electrical hookup. CIRCULATION PUMP INSTALLATIONS: 1.Install the original electrical cord onto the new pump. 2.Reverse steps 3 to 7 of the Circulation Pump Removal instructions. 3.Check for water leaks. 4.Reconnect power to the spa. 5.Perform a water flow test. (1 GALLON WITH 20 SECONDS) 6.Check for any air in the plumbing lines. If air does not clear, bleed off the air at the closest tubing clamp. 7.Reinstall the equipment compartment door. 2008 Watkins Manufacturing Corporation. CDR is a trademark of Watkins Manufacturing Corporation